Dobinsons MRR 75mm Lift Kit - Gen 2 Mazda BT50 (2011-07/2020)

The Dobinsons MRR lift kit is the ultimate in lift kits for your 4WD. It combines the known quality of Dobinsons components with the performance of a Monotube Remote Reservoir 50mm bore shock and is height adjustable, meaning you can fine tune your ride height to your desired look, or to increase lost height when new accessories have been fitted

This is a complete Dobinsons MRR lift kit for a Gen 2 Mazda BT50 (2011-07/2020)

The kit contains:

• 2x Dobinsons MRR Front Shock absorbers
• 2x Dobinsons Front Coil Springs 
• 2x Dobinsons MRR Rear Shock absorbers
• 2x Dobinsons Raised Leaf Springs
• 1x Tailshaft Centre Bearing Spacer Kit
• 4x HD U Bolts
• 1x Polyurethane Leaf Spring Bush Kit

--

Important Notes for setting up your Vehicle Correctly:

• When selecting Springs to suit your lift, please Select Springs only to suit Current "CONSTANT" Loads Front and Rear.
• Towing Loads are not included in your Constant Load Calculations, as they are not "Constant" Loads.
• Please do not put Occasional Loads into your "Constant" Load determinations.
• Selecting a load rating that is too heavy for your setup will result in Poor Flex Off-Road, Compromised Suspension Travel & Rough Ride, and will cause damage to your new shock absorbers and other components by pushing them outside of their intended range.

Please Note:

• All lift heights stated are estimated lift heights, due to the large number of variables in each different vehicles setup and accessories. 
• Estimated Lift Height:
• Front 75mm
• Rear 40-50mm 2", 60mm or 75mm 3"