Dobinsons Nitro Gas 40-45mm Front Lift Kit - Isuzu MU-X UCS40 (08/2021-On)

Dobinsons Twin-Tube Nitro Gas shock absorbers are designed, developed and tested in Australia to ensure that every shock can withstand the blistering heat and endless corrugations of the Australian Outback. 

Dobinsons Nitro Gas feature:

• 51mm Body Size w/ a Double-Chromed 18mm Piston Rod
• High-Quality Fuchs Oil
• Teflon Piston Rings
• Genuine NOK Seals
• Dust Boot For Added Protection
• Vehicle & Weight specific Valving
• Natural Rubber Bushes
• Direct Bolt On (No Mods Required)

The kit contains:

• 2x Dobinsons Nitro Gas Front Shock absorbers
• 2x Dobinsons Front Coil Springs
• 2x Heavy Duty Strut Top Mounts

Important Notes for setting up your Vehicle Correctly:

• When lifting the Front in these they are very sensitive to changes on Height with the Steering Geometry.
• They will sit Extremely High with Bad Toe in and Positive Camber until wheel aligned.
• ** It is Critical not to fit Heavy Duty Springs to suit Accessories that are not fitted yet fitted, or you are going to have problems with alignment and electronics **
• We recommend fitting Accessories 1^st and then set the Suspension up to cope with them.
• Front Ride Height can vary by as much as 20-25mm before and after alignment on this model.
• Height Measurements cannot be done until the vehicle is wheel aligned.
• We recommend vehicles are not driven until they are Wheel aligned.
• When selecting Springs to suit your lift, please Select Springs only to suit Current "CONSTANT" Loads Front and Rear.
• Towing Loads are not included in your Constant Load Calculations, as they are not "Constant" Loads.
• Please do not put Occasional Loads into your "Constant" Load determinations.
• Selecting a load rating that is too heavy for your setup will result in Poor Flex Off-Road, Compromised Suspension Travel & Rough Ride, and will cause damage to your new shock absorbers and other components by pushing them outside of their intended range.

Please Note:

• All lift heights stated are estimated lift heights, due to the large number of variables in each different vehicles setup and accessories.