Dobinsons Nitro Gas 75mm Lift Kit - Gen 3 Mazda BT-50 09/2020-On

Dobinsons Spring & Suspension established in 1953, is largely based on Leaf and Coil Spring Manufacturing and the supply of Suspension Components. With several generations of family ownership and experiences, Dobinsons has become one of the leaders in the Spring Industry in Australia applying the years of knowledge into their products. 

The kit contains:

• 2x Dobinsons Nitro Gas Front Shock absorbers
• 2x Dobinsons Front Coil Springs (multiple rates to suit your vehicle)
• 2x Dobinsons Nitro Gas Rear Shock absorbers
• 2x Dobinsons 40mm Raised Leaf Springs
• 4x HD U Bolts
• 1x  Polyurethane Bush Kit (Leaf Spring)

Please note: This kit requires the addition of aftermarket Upper Control Arms and a Diff Drop Relocation Kit

Important Notes for setting up your Vehicle Correctly:

• When lifting the Front in these they are very sensitive to changes on Height with the Steering Geometry.
• They will sit Extremely High with Bad Toe in and Positive Camber until wheel aligned.
• ** It is Critical not to fit Heavy Duty Springs to suit Accessories that are not fitted yet fitted, or you are going to have problems with alignment and electronics **
• Front Ride Height can vary by as much as 20-25mm before and after alignment on this model.
• Height Measurements cannot be done until the vehicle is wheel aligned.
• We recommend vehicles are not driven until they are Wheel aligned.
• When selecting Springs to suit your lift, please Select Springs only to suit Current "CONSTANT" Loads Front and Rear.
• Towing Loads are not included in your Constant Load Calculations, as they are not "Constant" Loads.
• Please do not put Occasional Loads into your "Constant" Load determinations.
• Selecting a load rating that is too heavy for your setup will result in Poor Flex Off-Road, Compromised Suspension Travel & Rough Ride, and will cause damage to your new shock absorbers and other components by pushing them outside of their intended range.

Please Note:

• All lift heights stated are estimated lift heights, due to the large number of variables in each different vehicles setup and accessories. 
• Parabolic Leaves are suited to Empty Vehicles Only, not Vehicles carrying a Constant Load.
• Estimated Lift Height
• Front 75mm 
• Rear 40-50mm