Trac Electronics High Mount Brake Light Delete Patch Harness - Gen 3 Isuzu d-Max 08/2020-On & Gen 3 Mazda BT-50 09/2020-On

When fitting a canopy or service body the rear high brake light should be disconnected to avoid glare in the rear-view mirror every time the brakes are applied.

If the rear high brake light lens cannot be removed due to a canopy or service body already in place, or you do not want to disturb the seal between the lens and vehicle body our rear high brake light delete patch harness can be utilised.

Description:
This patch harness is easily fitted as the connection is inside the vehicle behind the driver’s side kick panel, just disconnect an existing factory connector and fit our high brake light delete patch harness between the two existing factory connectors.

NO factory wires are required to be severed this is completely reversable, should your situation change and the canopy or service body is removed.

Installation:
First remove the plastic skirting on the driver’s door then the plastic kick panel, disconnect existing factory connectors and fit our high brake light delete patch harness between the two existing factory connectors refit trim.